What to be for Halloween this year? That was the question that spurred a marathon 20 hour pursuit for the perfect recognizable costume. It was four days before our annual Halloween party and I still had no idea what I was going to do. My wife finally decided to do characters from the Wizard of Oz. I was to be the Tinman and she was going as Dorothy.
I searched the internet but could not come up with what I felt was a worthy rendition so I did the next best thing, I went to the drawing board. The following steps/pictures will guide you to your very own sheet metal homemade Tinman costume.
I began with a picture I downloaded from the movie. This served as my inspiration throughout the building process. Your shopping list is fairly short but don't be fooled what the lack of materials will be made up by the amount of individual construction.
The list is as follows: 1 roll of 20"x50' of metal flashing (Lowes $55), two boxes of 100 8/32 1/2 bolts with nuts (Lowes $12), one roll of pipe hanger (Lowes $5), one roll of aluminum tape (Lowes $9), one large funnel($5), face paint ($4), silver hairspray ($4), silver spray paint ($5), six pieces of poster-board ($6), one foot of small chain ($1).
Tools required for construction: Drill and 1/4 bit, tin snips, screw driver, rubber mallet, marker, poster board, scissors, tape measure,a steady hand and a lot of patience.
I began with making a poster-board 3-d mock up, I made the main body by wrapping a couple of pieces of poster-board around myself and cutting holes for the arms. Then place a piece of poster board over the top and trace the oval shape, remember to add tabs to attach it before you trace it on your metal. Then for the arms and legs simply wrap your upper arm/lower arm, and repeat the process for the legs. Remember to leave about an inch of overlap for the bolts to hold.
Now time for the knees and elbows, the elbows will take some trial and error, simply cut a rectangle big enough to cover your elbow and cut opposing lines toward the middle stopping about 2 inches from the middle. For the knees cut larger rectangles and round out the edges per your taste. The next thing is the shoulder pads simple cut crescent moon shapes 3 for each side, attach at the corners and separate to make the desired shape.
Lastly is the chin and hat (funnel). I held a piece of 2 inch cardboard around my chin and had my wife trace it, then attach the piece to a strap that goes over your head, this is held in place by one that goes over the top of your ear around behind the head.
All these measurements are sized to the individual wearing the suit. Take your time and make your model look just like you want your costume to look. Once that is done, carefully disassemble your poster board model and trace each piece onto your metal. Carefully cut out the pieces and attach them by drilling and using your bolts and nuts. I found one bolt about ever 4 inches works best.
I know this is a lot of information but with a little ingenuity you will have a great homemade Tinman costume. Have Fun.